Re: Graphics Builder Y-Axes Width

Adriano,

Many thanks, but I've done that and that doesn't make a difference. To see if you get the same error, set the MAX value of the axes very high and see if the display itis ############# just while editing the chart. The mask doesn't enter into be, because eventually there will be a number that doesn't fit.

Thanks for your help?

Any other ideas?

In article <85cmtn$2i7$1_at_nnrp1.deja.com>,   Adriano Prado <prado_at_gmx.net> wrote:
> Well, you could try changing the number mask of y-axis, increasing it
> to a number you think will be the max (e.g., 999999999999).
>
> To have a better ideia about number masks, take a look at this site:
> http://infoboard.com/packagedoc/oradoc/DOC/server/doc/SP33/ch6a.htm
> and go the COLUMN section.
>
> And how to pre-determine the size of the label... it depends on you
> database.
>
> bye
> Adriano.
>
> In article <85bs82$geq$1_at_nnrp1.deja.com>,
> egil22_at_my-deja.com wrote:
> > I've got a Graphics Builder OGD chart embedded in a Report from
Report
> > Builder 6.0.
> >
> > Everything works great until the labels on the Y-axes get greater
than
> > 10 characters they appear as ############.
> >
> > Does anyone know how to pre-determine the width of the label?
> >
> > Many thanks
> >
> > Egil
> >
> > Sent via Deja.com http://www.deja.com/
> > Before you buy.
> >
>
> Sent via Deja.com http://www.deja.com/
> Before you buy.
>

Sent via Deja.com http://www.deja.com/
Before you buy. Received on Wed Jan 12 2000 - 01:43:54 CET