Re: Adding joint nodes to Designer 2000 ERDs?

Do a shift click on the relationship to create a bend. IHTH
Mark

Mark Kramm wrote in message <7aeite$ghs_at_bgtnsc02.worldnet.att.net>...
>select one relationship, then do a edit->select same type. (this will
select
>all relationships in the ERD. then press the autolayout button this will
>straighten out all the relationships.
>
>IHTH
>Mark
>
>Richard Billingsley wrote in message <36C3D065.6CDACDEA_at_deadend.com>...
>>Is there a way to add joint nodes to a Designer 2000 ERD? I can't find
>>any information on the matter. Designer 2000 does a rotten job of
>>laying out the entities and when I attempt to rearrange them I get lines
>>going all over the place and can't figure out how to clean it up. I
>>want to add more node joints to the relationship lines but can't figure
>>out how to do it.
>>
>>Thanks,
>>
>>Richard..
>>
>>--
>>Richard Billingsley
>>
>>Note: To reply via email replace "deadend.com" with "csi.com" before
>>sending.
>>
>>
>
>
Received on Wed Feb 17 1999 - 15:22:31 CET