OraFAQ Forum: Forms » How to change canvas sequences of a form

Home » Developer & Programmer » Forms » How to change canvas sequences of a form

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

How to change canvas sequences of a form [message #232442]

Fri, 20 April 2007 09:42

houbcm
Messages: 14
Registered: April 2007

Junior Member

I created a form with two canvases, and want to call the second canvas from the first one. But every time when i ran the form, the second canvas showed up first. How to solve this problem?

Thanks.

Report message to a moderator

Re: How to change canvas sequences of a form [message #232446 is a reply to message #232442]

Fri, 20 April 2007 09:58

kamran.it
Messages: 265
Registered: September 2005
Location: Karachi

Senior Member

My dear this topic has discussed earlier any way.

Create a button in main form and write code in when-button-press trigger go_block ('blockname');

Report message to a moderator

Re: How to change canvas sequences of a form [message #232448 is a reply to message #232442]

Fri, 20 April 2007 10:05

houbcm
Messages: 14
Registered: April 2007

Junior Member

I did the same thing. The problem is when i ran the form, the second canvas showed up first, not the main canvas. So how to change something to show the main canvas first?

Report message to a moderator

Re: How to change canvas sequences of a form [message #232449 is a reply to message #232448]

Fri, 20 April 2007 10:11

kamran.it
Messages: 265
Registered: September 2005
Location: Karachi

Senior Member

double click on your module
under the navigation
set the first navigation data block as your first canvas

Report message to a moderator

Re: How to change canvas sequences of a form [message #232657 is a reply to message #232442]

Sun, 22 April 2007 21:04

djmartin
Messages: 10181
Registered: March 2005
Location: Surges Bay TAS Australia

Senior Member
Account Moderator

Change the 'Raise on Entry' property of the second canvas to 'no'.

Also make sure that when your form starts that the 'focus' (the item in which the cursor is sitting) in not on the second canvas.

David

Report message to a moderator

Re: How to change canvas sequences of a form [message #232837 is a reply to message #232442]

Mon, 23 April 2007 09:25

imen_mr2004
Messages: 22
Registered: October 2006
Location: tunisia

Junior Member

the solution is to try to put the data block which is contained by the canevas u want it to appear first, first in the datablock area
Good luck

Report message to a moderator

Previous Topic:	How to create a data block without table info
Next Topic:	How can define the format mask

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sat May 09 01:20:44 CDT 2026