Home » Developer & Programmer » Forms » FRM-18122: Oracle Forms debugger failed to initialize
FRM-18122: Oracle Forms debugger failed to initialize [message #685426] Tue, 04 January 2022 04:39 Go to next message
jury68000
Messages: 33
Registered: October 2019
Member
We started the process of transition from 10g to 12c.
When I run 12c I always get below error right after it starts:
"FRM-18122 : Oracle Forms debugger failed to initialize"

I have seen the likes:
https://community.oracle.com/mosc/discussion/4085204/frm-18122-oracle-forms-debugger-failed-to-initialize
https://community.oracle.com/mosc/discussion/4157318/frm-18122-oracle-forms-debugger-failed-to-initialize
and some other ones, but everywhere its said to set FORMS_BUILDER_CLASSPATH as a remedy.
But it is set up as seen in the attachement. All paths there are correct.
What can be wrong?


Forms 12c on Windows 10

Report message to a moderator

Re: FRM-18122: Oracle Forms debugger failed to initialize [message #686251 is a reply to message #685426] Wed, 13 July 2022 02:54 Go to previous message
jury68000
Messages: 33
Registered: October 2019
Member
Answering Michel's question from here:

http://www.orafaq.com/forum/mv/msg/208069/686250/#msg_686250

no, I'm still looking for a way to start debugger in 12c. Hopefully our transition process is really slow (so far we switched just maybe 1% of forms modules to 12c) so I can still mostly use 10g with its debugger. So any ideas are welcome.

Report message to a moderator

Previous Topic: .fmb to .txt
Next Topic: Slow performance when retriving data
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Tue May 26 00:51:41 CDT 2026
.:: Forum Home :: Blogger Home :: Wiki Home :: Contact :: Privacy ::.