Home » Developer & Programmer » Reports & Discoverer » Report allignment problem (Oracle 10G)
Report allignment problem [message #571857] Mon, 03 December 2012 01:00 Go to next message
poojamunj
Messages: 64
Registered: May 2011
Location: MUMBAI
Member
Hello,
I have developed one report. When I get the output through report builder, I am getting the output on entire page i.e. the output is getting adjusted in entire area. But when I put the report on test server, the output comes in pdf format which is ok but the output is getting shrinked because of which lot of paper area is getting wasted. How can I get the output in the entire paper area even through pdf. Are there any setting in report builder. Please help.

Report message to a moderator

Re: Report allignment problem [message #571861 is a reply to message #571857] Mon, 03 December 2012 01:50 Go to previous message
ranamirfan
Messages: 535
Registered: January 2006
Location: Pakistan / Saudi Arabia
Senior Member
Dear,

Try this.

1- Set System Paramter MODE = Default
2- Set System Paramter DESFORMAT=HTML
3- On Report level Property Inspector under Report Escapes
After page Value=
<table style="page-break-before: always; height=0" ></table >

Hope it'll help you.

Regards,
Irfan

Report message to a moderator

Previous Topic: Building an Across/Down Group Report
Next Topic: excel sheet output from oracle report builder
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sun Mar 22 15:11:55 CDT 2026
.:: Forum Home :: Blogger Home :: Wiki Home :: Contact :: Privacy ::.