Home » Developer & Programmer » Reports & Discoverer » How to call report parameter at runtime? (Report 6i)
How to call report parameter at runtime? [message #420083] Wed, 26 August 2009 23:47 Go to next message
mm_kanish05
Messages: 493
Registered: January 2007
Location: Chennai
Senior Member
Hi,
Is there any possible to call report parameter at runtime at values fails in case of 1st attempt?

Reports 6i

kanish

Report message to a moderator

Re: How to call report parameter at runtime? [message #420220 is a reply to message #420083] Thu, 27 August 2009 10:19 Go to previous message
cookiemonster
Messages: 13975
Registered: September 2008
Location: Rainy Manchester
Senior Member
I'm afraid I have no idea what that means

Report message to a moderator

Previous Topic: How Can Find Out That Doument is printed Successfully
Next Topic: can't pass parameter through cgicmd.dat key
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Fri May 08 18:43:17 CDT 2026
.:: Forum Home :: Blogger Home :: Wiki Home :: Contact :: Privacy ::.