Oracle FAQ | Your Portal to the Oracle Knowledge Grid |
Home -> Community -> Usenet -> c.d.o.server -> Re: when install 9.2.0.6 rac , cluster nodes can't be found
DA Morgan wrote:
> yuefuli_at_gmail.com wrote:
> > hi, I try to install 9.2.0.6 rac, and I use 9.2.0.4 package and 9.2.0.6
> > patch. my platform is rhel3u3
> >
> > I referenced the article : Step-By-Step Installation of 9.2.0.5 RAC on
> > Linux(http://metalink.oracle.com/metalink/plsql/ml2_documents.showDocument?p_database_id=NOT&p_id=184821.1).
> >
> >
> >
> >
> > I installed 9.2.0.4 cm, 10.1.0.3 installer, 9.2.0.6 cm. and then
> > I try to install 9.2.0.4 oracle .
> > I started oracm on both node1 and node2, from their cm.log I think
> > oracm works fine.
> > and I tested rsh, rcp , they works fine, too.
> >
> > but when I install 9.2.0.4 Oracle, the node selection screen did't
> > appear, I don't know the reason.
> >
> > any advice is appreciate.
> > thanks.
>
> Then, by definition, Cluster Manager did not start (or restart).
> --
> Daniel A. Morgan
> http://www.psoug.org
> damorgan_at_x.washington.edu
> (replace x with u to respond)
thanks. but how can I make sure if CM works fine?
I use ps -efm |grep oracm, I get many threads.
and I check cm.log, I get
Successful reconfiguration, 2 active node(s) node 0 is the master, my node num is 0 (reconfig 2) {Fri Jan 21 11:39:51 2005 }^M and node2 has similar message.
is there any other way to check if oracm works fine?
thanks a lot. Received on Sun Jun 26 2005 - 20:14:51 CDT