Re: dataguard Broker

Can you send the full set of steps, commands, show configuration and show database verbose, for the broke configuration?

Sent from my iPad

> On Oct 11, 2018, at 04:59, Howard Latham <howard.latham_at_gmail.com> wrote:
>
>
> Oracle 11.2.0.4 redhat 5.
>
> I just cant get it to work!
> Everything in the DGB setup looked fine. Even got it checked by a third party.
> But just as last time we tried we got a message from broker saying cannot switchover and primary was still primary but when I looked
> then we had two standbys. Nightmare!
>
> My question is why did that happen?
>
> The standby/primary pair operate fine manually but I really wanted to use DGB.
>
>
> My method to recover from this was
>
>
>
> 1. Connect to standby which should be primary. Alter database activate standby database;
> 2. Rman into standby which should be standby – restore database;
> 3. Start recovery at end of restore.
>
>
>
>
>
>
>
>
>
> Howard A. Latham
>
>

--
http://www.freelists.org/webpage/oracle-l