Re: Adding joint nodes to Designer 2000 ERDs?

[Quoted] select one relationship, then do a edit->select same type. (this will select [Quoted] all relationships in the ERD. then press the autolayout button this will straighten out all the relationships.

IHTH
Mark

Richard Billingsley wrote in message <36C3D065.6CDACDEA_at_deadend.com>...
>Is there a way to add joint nodes to a Designer 2000 ERD? I can't find
>any information on the matter. Designer 2000 does a rotten job of
>laying out the entities and when I attempt to rearrange them I get lines
>going all over the place and can't figure out how to clean it up. I
>want to add more node joints to the relationship lines but can't figure
>out how to do it.
>
>Thanks,
>
>Richard..
>
>--
>Richard Billingsley
>
>Note: To reply via email replace "deadend.com" with "csi.com" before
>sending.
>
>
Received on Wed Feb 17 1999 - 15:15:10 CET