Designer 2000/Reports 2.5 Question

[Quoted] I'm writing a master detail detail break report. I diagrammed my module in the Data Diagrammer but when I run it I loose the boilerplate my last column. For example my report would look as follows:

xxxxx	xxxxx
xxxxx	xxxxx

 xxxxx    

  xxxx xxxx xxxxx xxxx xxxx

• ---- ---- ---- ---- xxx xxx xxxx xxx xxx xxx xx xxx xxx xxx

 xxxx

  xxxx xxxx xxxx xxxx xxxx

• ---- ---- ---- xx xxx xxx xxx xxxx xxx xxx xxx xxx xxxx

It continues this way til the end of the report. When I take the report into Report Designer and try to run it I get a message that my frame intersects but does not enclose the object. Any ideas would be greatly appreciated.

Cary Ataman Received on Tue Mar 11 1997 - 00:00:00 CET