Re: Configure Oracle on two-nodes HP cluster (without RAC)

From: hpuxrac <johnbhurley_at_sbcglobal.net>
Date: 21 Jun 2006 05:34:55 -0700
Message-ID: <1150893295.394202.215870@p79g2000cwp.googlegroups.com>

questn_at_mail.ru wrote:
> Hi
>
> Yesterday I was given two-nodes HP server. This two-nodes connects to
> HP storage through FC. There are HP-UX operating system on them.
> Cluster software is configured with Service Guard.
> And I need to configure Oracle 10G (without RAC) to run on it.
>
> I'm DBA so have little experience to configure hardware cluster.
> So I need help. May be there are some information about this theme in
> the Net.
> I have looked for it in HP.COM but there was nothing.
>
> Thanks in advance.

Sounds like you want a service guard fail over cluster configuration?

That's a pretty typical service guard setup where if oracle or one side of the cluster fails oracle will be restarted on the other side of the cluster.

This is much more of a service guard configuration issue than it is an oracle issue. You will have a package defined in service guard that will move between the machines.

Start reading HP service guard documentation is my advice. HP does offer some classes in service guard. Received on Wed Jun 21 2006 - 07:34:55 CDT