Oracle FAQ | Your Portal to the Oracle Knowledge Grid |
Home -> Community -> Usenet -> c.d.o.server -> Re: using dbv to check a segment
From Oracle9i, there are two command-line interfaces to DBVERIFY.
1) With the first interface, you specify disk blocks of a single
datafile for checking.
2)With the second interface, you specify a segment for checking. This
mode requires that you specify a segment (data or index) to be
validated. It also requires that you log on to the database with
SYSDBA privileges, because information about the segment must be
retrieved from the database.
I think you need not give " as sysdba"
Try this
dbv userid=sys/xxxx
regarding tsn, i think it is table segment name ?
i dont know if i'am right
regards
Srivenu
Received on Wed Aug 28 2002 - 00:46:27 CDT