Oracle FAQ | Your Portal to the Oracle Knowledge Grid |
Home -> Community -> Usenet -> c.d.o.server -> Re: witing an oracle nt service
Typing "net helpmsg 2140" will probably piss you off even more...
Does this service interact with the desktop, does the account (if it does) have all the correct rights, try to get it to use a new account that has all rights enabled...
Just a shot in the dark.
Regards
Adrian
Steve Haynes wrote in message <6DoKFAAn0pi1Ewq4_at_rwx777.demon.co.uk>...
>Hi All,
>This is not strictly an oracle question but
>I'm a bit stumped as to who to ask.
>I'm writing a cron for nt4 in pro*c
>which fires off commands/procedures etc
>with features that the job control doesn't
>provide (before somebody mentions that).
>I have integrated my code with the VC++ 5
>service example code and the service
>installs/deinstalls and runs as command line
>in debug mode just fine. But when I start the
>serice via control panel I get NT internal error 2140.
>Game over, no clues at all.
>I have also increased the default timeouts on
>"service starting" messages to 9000 millisecs
>so I don't think its that.
>Any suggestions welcomed...
>Thanks
>Steve Haynes
>--
>"The floggings will continue until morale improves."
>
Received on Fri Jun 19 1998 - 17:53:21 CDT