Re: How to change REPORTS synonym?

From: Ko Ho Yuen <tomas_at_cs.ust.hk>
Date: 1996/11/14
Message-ID: <56dt97$p6l@ustsu10.ust.hk>#1/1

Ko Ho Yuen (tomas_at_cs.ust.hk) wrote:
: Ron Moeller (rmoeller_at_ladc.lockheed.com) wrote:
: : I'm using run_product(REPORTS,...) in forms and getting a bad
: : printout. It matches bug 277288 which implies I'm running
: : Reports in character mode when I have a bit-map environment.

: : Where does this REPORTS synonym/parameter exist and how do I
: : change it. (I believe it incorrectly refers to runrep25m when it
: : should refer to r25runmg.)
: There is a system parameter in Report2.5 that controls this. I think
: it's called DESTYPE but not sure. Please check the manual to confirm
: this. You can set the value to "bitmap". Hope it'll work.
Sorry for making a mistake here, I didn't have the manual at hand last night. The correct parameter should be MODE, which is a system parameter.

Tomas Received on Thu Nov 14 1996 - 00:00:00 CST