Oracle FAQ | Your Portal to the Oracle Knowledge Grid |
Home -> Community -> Usenet -> c.d.o.misc -> Re: Designer/2000 : Problem with item groups formatting
You gave your own answer...
pawan_at_ggn.hcltech.com wrote:
> HI,
>
> I am using Designer 1.3.2. While using Module Data Diagrammer, I am having
> problems with Item Groups. I define few items in item group. I give alignment
> = SS (GRPTUT = SS) and i define corresponding Table as 2.14.41.53 (GRPTAB =
> 2.14.41.53, for tab alignments of prompts and items). When I generate forms,
> items are not formatted according to tab settings defined. It seems problem
> comes, only when, items can fit in one line without this formatting
<snip>
Yep, that's it - make sure to "force" line wrapping, else it won't work.
Decrease the width of your screen to such extent that formatting
will occur - it's a known "feature"
> Now i tried for these alignments at block level. Problem comes with items in
> block, when no. of items is less and they can fit in a line.
Same story: when all items fit, no formatting is done; only when e.g. wrapping
should occur. BTW decreasing your width to an extent where wrapping will occur
sometimes will result in wrapping. However, it's my experience, that there's a
"sensitive" zone, where formatting will, but wrapping will not occur.
Good luck!
--
Frank van Bortel
Technical Consultant Oracle
V&L Informatica BV
Work Home Postbus 545 Hunzestraat 4 7500 AM Enschede 7555 WB Hengelo (31)53.434.1500 (31)74.242.5046Received on Wed Apr 07 1999 - 04:32:24 CDT