RE: Error while adding new node

A long shot - verify that X11 forwarding is no in the ssh_config files of both nodes. I have had problems with that before where internode connectivity is affected (I believe that there is a ML note on that). I would suspect that the second message is as a consequence of the first, but regardless, resolving the first error would verify that.  

-Krish
 

From: oracle-l-bounce_at_freelists.org [mailto:oracle-l-bounce_at_freelists.org] On Behalf Of Murtuja Khokhar
Sent: Sunday, April 27, 2008 10:34 PM
To: oracle-l_at_freelists.org
Subject: Error while adding new node  

Hi,  

I have two node RAC setup. I am using Oracle 10g Standard Edition (10.2.0.3.0) on Solaris 10 (sparc 64bit).

I am testing node crash scenario so I have deleted one node. I have followed steps from ML#269320.1.After deleting node successfully I have tried to add node. For adding node I have followed ML#270512.1  

When I started to add new node, I was able to add clusterware to new node. VIPCA was successful.

but when I tried to add Oracle Software on new node ,I am getting error message like "The selected remote nodes are not accessible" and "The virtual host name for node is already in use"  

For troubleshoot this error :  

I have checked user equivalence (SSH) is OK and All nodes can ping each other.

vip is configured properly and both are on eri0:1 and I can ping both vip from each node.  

Can you please suggest me fix for this error?  

--

http://www.freelists.org/webpage/oracle-l Received on Mon Apr 28 2008 - 00:36:57 CDT