Home » Developer & Programmer » Forms » rollback in stored procedure
rollback in stored procedure [message #269708] Mon, 24 September 2007 04:12 Go to next message
petku
Messages: 10
Registered: September 2007
Junior Member
Hi,

I have to perform a rollback in a procedure which is activated when a user clicks a button.

Unfortunately forms rolls back the contents of no-database-blocks too - all blocks are empty then.

To restore the contents give a little bit trouble because the user navigates to the corresponding button through different canvases.

Any ideas?

Regards,
Peter

[Updated on: Mon, 24 September 2007 04:25]

Report message to a moderator

Re: rollback in stored procedure [message #272909 is a reply to message #269708] Mon, 08 October 2007 02:44 Go to previous message
djmartin
Messages: 10180
Registered: March 2005
Location: Canberra ACT Australia
Senior Member
Account Moderator
Did anyone tell you anything other than that this can't be done?

David
Previous Topic: FRM-18108
Next Topic: Displaying Rows into Detail Table
Goto Forum:
  


Current Time: Sat Dec 03 20:14:04 CST 2016

Total time taken to generate the page: 0.08065 seconds