Home » RDBMS Server » Server Administration » installing two oracle_home
installing two oracle_home [message #260088] Fri, 17 August 2007 06:58 Go to next message
vijaychauhan
Messages: 106
Registered: December 2005
Senior Member
hi!
I am using windows xp and had installed oracle 9ir2 on it, then I, installed 10gr2 on the same server, the installtion went fine, but later I tried to start dbca for 9i , it only goes till the last screen of dbca, where it ask for finish button, but then it does not give any response. also I, do not see oracle_home for 10g in windows registry.
Re: installing two oracle_home [message #260295 is a reply to message #260088] Sat, 18 August 2007 03:10 Go to previous messageGo to next message
NandKumar
Messages: 92
Registered: June 2007
Location: v$hyderabad
Member
you can browse to the oracle9i bin directory, and double click the dbca.bat....or cd to the bin directory of oracle 9i and at command prompt run dbca. I think this will help.
Re: installing two oracle_home [message #260337 is a reply to message #260295] Sat, 18 August 2007 10:27 Go to previous messageGo to next message
vijaychauhan
Messages: 106
Registered: December 2005
Senior Member
hi!
There is no problem with invoking of dbca, but when i click on finish there is no response, the finish is the last click button of dbca.
Re: installing two oracle_home [message #260415 is a reply to message #260337] Sun, 19 August 2007 11:35 Go to previous message
Littlefoot
Messages: 20888
Registered: June 2005
Location: Croatia, Europe
Senior Member
Account Moderator
Quote:
I installed oracle 9ir2 on it, then I, installed 10gr2 on the same server

Did you install those products into DIFFERENT Oracle Homes? If not, well, you should have.
Previous Topic: Oracle is consuming all available memory
Next Topic: Monitor TABLESPACES 10g
Goto Forum:
  


Current Time: Sat Dec 03 01:25:00 CST 2016

Total time taken to generate the page: 0.04953 seconds