Home » Developer & Programmer » Forms » How to change canvas sequences of a form
How to change canvas sequences of a form [message #232442] Fri, 20 April 2007 09:42 Go to next message
houbcm
Messages: 14
Registered: April 2007
Junior Member
I created a form with two canvases, and want to call the second canvas from the first one. But every time when i ran the form, the second canvas showed up first. How to solve this problem?

Thanks.
Re: How to change canvas sequences of a form [message #232446 is a reply to message #232442] Fri, 20 April 2007 09:58 Go to previous messageGo to next message
kamran.it
Messages: 265
Registered: September 2005
Location: Karachi
Senior Member
My dear this topic has discussed earlier any way.

Create a button in main form and write code in when-button-press trigger go_block ('blockname');
Re: How to change canvas sequences of a form [message #232448 is a reply to message #232442] Fri, 20 April 2007 10:05 Go to previous messageGo to next message
houbcm
Messages: 14
Registered: April 2007
Junior Member
I did the same thing. The problem is when i ran the form, the second canvas showed up first, not the main canvas. So how to change something to show the main canvas first?
Re: How to change canvas sequences of a form [message #232449 is a reply to message #232448] Fri, 20 April 2007 10:11 Go to previous messageGo to next message
kamran.it
Messages: 265
Registered: September 2005
Location: Karachi
Senior Member
double click on your module
under the navigation
set the first navigation data block as your first canvas
Re: How to change canvas sequences of a form [message #232657 is a reply to message #232442] Sun, 22 April 2007 21:04 Go to previous messageGo to next message
djmartin
Messages: 10180
Registered: March 2005
Location: Canberra ACT Australia
Senior Member
Account Moderator
Change the 'Raise on Entry' property of the second canvas to 'no'.

Also make sure that when your form starts that the 'focus' (the item in which the cursor is sitting) in not on the second canvas.

David
Re: How to change canvas sequences of a form [message #232837 is a reply to message #232442] Mon, 23 April 2007 09:25 Go to previous message
imen_mr2004
Messages: 22
Registered: October 2006
Location: tunisia
Junior Member
the solution is to try to put the data block which is contained by the canevas u want it to appear first, first in the datablock area
Good luck
Previous Topic: How to create a data block without table info
Next Topic: How can define the format mask
Goto Forum:
  


Current Time: Sat Dec 10 07:19:20 CST 2016

Total time taken to generate the page: 0.12024 seconds