Home » Developer & Programmer » Reports & Discoverer » Report property setting
Report property setting [message #224856] Thu, 15 March 2007 14:40 Go to next message
Messages: 1
Registered: March 2007
Location: CHENNAI
Junior Member
Hi All,
I have been assigned a task of printing a label in the pre printed stationary. The label definition is as follows

Top margin : .2 cms
body: 4 cms
bottom margin : .15 cms

For the above label setup I created a report with the following settings
Character mode
Report height : 11
report width : 80
Section height : 2.2
Section width : 25

Prt file setup;
Height : 11
Width : 80

If i run the report in character mode, the label height is setting at 4.2cms or in 4.3 cms. I am not able to set it in 4.35 cms.

Is it possible to set in 4.35 cms or 4.4 cms?

Thanks in advance


Re: Report property setting [message #224993 is a reply to message #224856] Fri, 16 March 2007 07:56 Go to previous messageGo to next message
Messages: 25
Registered: September 2006
Junior Member
generally in charcter mode reports this problem will occur,to resolve this you have to set the report property's
like format
if you set the exactly format with the same exactly length and width then the out put will come same like a default report
Re: Report property setting [message #282214 is a reply to message #224856] Wed, 21 November 2007 03:36 Go to previous message
Messages: 38
Registered: April 2007
Location: Chennai

Hi ,

I'm aslo facing the same problem,but my problem is bit different my printer style is 15*12.
in the report main section i have give this size.itis working in report builder.
While in apps isit not taking page breakup.1inovice is ok and 2nd invoice is printing on the bottom of the 1st page and keep on printing on the 2nd page.
Can u u pls help me in this...

Previous Topic: Problem during Discoverer report exporting to another database
Next Topic: Syntax error with ( ) parenthesis
Goto Forum:

Current Time: Tue Aug 22 23:32:34 CDT 2017

Total time taken to generate the page: 0.05725 seconds