Home » Developer & Programmer » Reports & Discoverer » Report alignment changes from 3rd page
Report alignment changes from 3rd page [message #217157] Wed, 31 January 2007 20:41 Go to next message
illur81
Messages: 6
Registered: August 2005
Junior Member
Hey guys,

My report prints properly, when printed for each transaction or two transactions seperately, but when i print for more than that, the alignment goes wrong from 3rd page onwards, i.e 1st page and 2nd page gets printed properly, from 3rd page onwards, it moves up, doesnt start from the correct location where it is supposed to start from. This is a cheque printing report, CAn someone help me to understand the issue, Any help on this issue is appreciated. Btw I am using report builder 6i. Its a bit urgent and quick help would be great.

Thanks
- Sandeep
Re: Report alignment changes from 3rd page [message #217369 is a reply to message #217157] Thu, 01 February 2007 20:32 Go to previous messageGo to next message
ab_trivedi
Messages: 460
Registered: August 2006
Location: Pune, India
Senior Member
hi sandeep,
you must check about the
Quote:
Vertical Elasticity and Horizontal Elasticity
of the frame and as well as of repeating frames, you are using.
I can understand that some of your fields are expanding which should not?Check and let me know?
Ashu
Re: Report alignment changes from 3rd page [message #217404 is a reply to message #217369] Fri, 02 February 2007 01:23 Go to previous messageGo to next message
illur81
Messages: 6
Registered: August 2005
Junior Member
Hey Ashu,

Thanks a lot for your suggestion, the issue was resolved before itself. The vertical elast was fixed instead of variable, which was causing the problem.

Thanks again for your suggestion.
Good luck
- Sandeep
Re: Report alignment changes from 3rd page [message #217555 is a reply to message #217404] Fri, 02 February 2007 14:48 Go to previous messageGo to next message
Ericle
Messages: 44
Registered: April 2006
Location: United States of America ...
Member

Why can't all problems be solved this easily? Razz

Eric

[Updated on: Fri, 02 February 2007 14:48]

Report message to a moderator

Re: Report alignment changes from 3rd page [message #217580 is a reply to message #217555] Fri, 02 February 2007 20:38 Go to previous messageGo to next message
ab_trivedi
Messages: 460
Registered: August 2006
Location: Pune, India
Senior Member
@Ericle i think there is no need to post because OP has already solved the problem!
Ashu
Re: Report alignment changes from 3rd page [message #217793 is a reply to message #217580] Mon, 05 February 2007 09:47 Go to previous messageGo to next message
Ericle
Messages: 44
Registered: April 2006
Location: United States of America ...
Member

Ashu, I already knew that, obviously. I was just making a little joke and the point was that I wish all problems could be solved as easily as this one. But, of course, that is not the case.
Re: Report alignment changes from 3rd page [message #217856 is a reply to message #217793] Mon, 05 February 2007 21:43 Go to previous message
ab_trivedi
Messages: 460
Registered: August 2006
Location: Pune, India
Senior Member
ok, What you think is true and if we work hard then all problems will be solved easily.
Ashu
Previous Topic: Help me!! Report uses Graphics
Next Topic: Report for Value Sets
Goto Forum:
  


Current Time: Wed Dec 07 03:13:34 CST 2016

Total time taken to generate the page: 0.13841 seconds