Home » Developer & Programmer » Warehouse Builder » OWB mapping loading from Flat file to Table
OWB mapping loading from Flat file to Table [message #193076] Thu, 14 September 2006 15:21
murur
Messages: 4
Registered: April 2006
Junior Member
I am importing data from flat file to table using owb mapping
I would like to stop if there is an error occured, in mapping configuration "ERROR_ALLOWED=0" I am getting an error on first record (inserting error record in rt_error table) but job status is "SUCCESS". this particular job is part of process flow I have to abort the process flow but control goes to next mapping as if this particular [problem]job completed successfuly...any help appriciated

Thank you
Previous Topic: TARGET CONNECTOR DOES NOT DEPLOY
Next Topic: VLD-1141 Error message
Goto Forum:
  


Current Time: Fri Dec 19 22:44:22 CST 2014

Total time taken to generate the page: 0.08831 seconds