Home » Open Source » Open Database Interfaces » ODBC Driver not found (Oracle 9i Client on Windows 7 x64)
ODBC Driver not found [message #550785] Thu, 12 April 2012 05:43 Go to next message
snehalgandhi
Messages: 36
Registered: February 2011
Location: Ahmedabad
Member
I have installed Oracle 9i client on Windows 7 64 bit. The installation went successfully fine. I am using DSN to run my application, so after installation i tried to create DSN using Oracle ODBC but i could not find the one in the list.
Can any one help on the same as earliest.

Report message to a moderator

Re: ODBC Driver not found [message #550787 is a reply to message #550785] Thu, 12 April 2012 06:00 Go to previous messageGo to next message
Michel Cadot
Messages: 54230
Registered: March 2007
Location: Nanterre, France, http://...
Senior Member
Account Moderator
You have to check "developer" option (name changes with every version and yours is very old) or the like during your installation.

Regards
Michel

Report message to a moderator

Re: ODBC Driver not found [message #550789 is a reply to message #550787] Thu, 12 April 2012 06:50 Go to previous messageGo to next message
snehalgandhi
Messages: 36
Registered: February 2011
Location: Ahmedabad
Member
Dear Michel,
Instead of Administrator version i have to install Developer version ??

Report message to a moderator

Re: ODBC Driver not found [message #550792 is a reply to message #550789] Thu, 12 April 2012 07:02 Go to previous messageGo to next message
Michel Cadot
Messages: 54230
Registered: March 2007
Location: Nanterre, France, http://...
Senior Member
Account Moderator
Yes, Administrator part does not contain drivers (it contains administrative tools).
You can install it in addition to administrative version, no need to deinstall it before, there is no incompatibility between the two.

Regards
Michel

Report message to a moderator

Re: ODBC Driver not found [message #560352 is a reply to message #550792] Thu, 12 July 2012 05:52 Go to previous message
dws1
Messages: 14
Registered: July 2012
Junior Member
iirc 9i is 32-bit-only, so to administer the ODBC DSNs in 64-bit Windows you need to use the 32-bit ODBC Administrator in C:\windows\syswow64\odbcad32.exe, NOT the one in Control Panel, which only administers the 64-bit ODBC drivers.

The lowest supported version of any Oracle software on Windows 7 is 10.2.0.5, so good luck with getting 9i working. You should really be using 11.2.0.3, but if you need 9i for some other reason (like: your application only works with 9i) then you'll have to downgrade your Windows to a version on which 9i was supported.

Report message to a moderator

Previous Topic: Unable to connect using ODBC (3 Merged)
Next Topic: Php gets stuck when inserting data to Oracle DB
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Fri May 24 10:30:16 CDT 2013

Total time taken to generate the page: 0.10641 seconds
.:: Forum Home :: Blogger Home :: Wiki Home :: Contact :: Privacy ::.