Home » RDBMS Server » Backup & Recovery » oracle 10g + ASM + block change tracking
oracle 10g + ASM + block change tracking [message #456776] Wed, 19 May 2010 08:39 Go to next message
caprikar
Messages: 222
Registered: March 2007
Senior Member
Hi,
I have oracle 10gR2 (ASM) running on HP-UX. I have enabled BCT but last week there was some problem in the disk group where I put the bct file and the diskgroup was dismounted because of which the BCT got disabled.
I haven't enabled the BCT yet, will my backup (incremental and merge) are still valid? or it is of no use until I run a full backup again?
Thanks
Re: oracle 10g + ASM + block change tracking [message #456795 is a reply to message #456776] Wed, 19 May 2010 08:55 Go to previous message
Michel Cadot
Messages: 59775
Registered: March 2007
Location: Nanterre, France, http://...
Senior Member
Account Moderator
Yes, there are valid.
BCT is only used to speed up the backup (when appropriately used).

Regards
Michel
Previous Topic: extract of Procedures
Next Topic: oracle
Goto Forum:
  


Current Time: Tue Nov 25 22:17:48 CST 2014

Total time taken to generate the page: 1.04533 seconds