Home » Developer & Programmer » Forms » Form calling proc using putty or plink command line (oracle 10g)
Form calling proc using putty or plink command line [message #435847] Fri, 18 December 2009 07:01 Go to next message
subhash_nyk
Messages: 2
Registered: September 2008
Location: Bangalore
Junior Member
Hi,

We migrated the oracle forms from 3.0 to 10g.
in 3.0 they are calling the pro* c using commandlne.
In 10g we are using third party Putty or Plink to call proc from forms.

When we using putty we are getting the error Libclntsh.so.10.1 cannot open shared object files error.
Re: Form calling proc using putty or plink command line [message #437124 is a reply to message #435847] Thu, 31 December 2009 03:01 Go to previous messageGo to next message
Littlefoot
Messages: 20900
Registered: June 2005
Location: Croatia, Europe
Senior Member
Account Moderator
I don't use Putty nor Plink nor Pro*C, but - if you did that job (in Forms 3.0) at the command line, why don't you do that in Forms 10g as well? Would it be possible to do that using the HOST built-in?
Re: Form calling proc using putty or plink command line [message #437756 is a reply to message #435847] Tue, 05 January 2010 23:08 Go to previous message
djmartin
Messages: 10180
Registered: March 2005
Location: Canberra ACT Australia
Senior Member
Account Moderator
Did Forms 10g successfully open a version 3 Form or did you have to step the form through Forms 4.5 first?

David
Previous Topic: 2 seconds delay before LOVS (merged 2)
Next Topic: General question
Goto Forum:
  


Current Time: Wed Dec 07 23:56:36 CST 2016

Total time taken to generate the page: 0.11435 seconds