Home » RDBMS Server » Enterprise Manager » RMAN jobs in Grid Control
RMAN jobs in Grid Control [message #378950] Sat, 03 January 2009 00:37 Go to next message
toshidas2000
Messages: 120
Registered: November 2005
Senior Member
I have a rman job which backs up a RAC database (4 node cluster). The backup runs through node 2. I want to edit it and make it run through node 4. I try to edit the job and then edit the target, but rest of the nodes are not listed there?? But if I go to all targets tab, I do see all targets. What am I missing??
Re: RMAN jobs in Grid Control [message #378984 is a reply to message #378950] Sat, 03 January 2009 09:24 Go to previous messageGo to next message
ebrian
Messages: 2794
Registered: April 2006
Senior Member
Why would you want to limit the backup to execute on only one node? That's the beauty of RAC, it will enable you to distribute the load of the backup amongst all the nodes. By limiting the backup to one node, what would happen if node 4 was down or inaccessible; the backup wouldn't run.
Re: RMAN jobs in Grid Control [message #379012 is a reply to message #378984] Sat, 03 January 2009 22:13 Go to previous message
toshidas2000
Messages: 120
Registered: November 2005
Senior Member
that's how it was design. Now I want to edit the target. Looks like I cannot edit a target, I can only add and remove targets. WHen I try to add a target, It does not show all nodes as target? Why and How can I fix it??
Previous Topic: OEM Configuration - Agent
Next Topic: Problems to configure destinations in EM Grid Control
Goto Forum:
  


Current Time: Sat Dec 10 14:56:33 CST 2016

Total time taken to generate the page: 0.07746 seconds