Home » Developer & Programmer » Reports & Discoverer » To display a title above a repeating frame (oracle report builder 10g)
To display a title above a repeating frame [message #358549] Tue, 11 November 2008 19:21 Go to next message
u_571_ddw
Messages: 2
Registered: August 2008
Junior Member

Hi,

I have a problem how to show title above on every column, using repeating frame which has print direnction : down/across.

In first jpg file (OP003.jpg) , i capture my repeating frame, The title "Transfer No" and "Status", is printed outside the repeating frame.
Inside the repeating frame, i have two fields : F_TRANSFER_NO and F_CONT_STATUS.

Then i run the reports(ctrl+Shift+R), the repeating frame shows up in three column, which only the first column has the title. The other two columns don't have the title above them. The attachment isin OP003result.jpg below.

How should i do to display the title above on every column shown?

Thanks a lot...

Rgds,

Darfan
  • Attachment: OP003.JPG
    (Size: 109.33KB, Downloaded 118 times)

[Updated on: Tue, 11 November 2008 19:22]

Report message to a moderator

Re: To display a title above a repeating frame [message #358551 is a reply to message #358549] Tue, 11 November 2008 19:23 Go to previous message
u_571_ddw
Messages: 2
Registered: August 2008
Junior Member

This is the capture of report's result...


Rgds,

Darfan
Previous Topic: Letters Reports in 10g
Next Topic: Not able to Print a PDF from Conc Prgm
Goto Forum:
  


Current Time: Fri Dec 02 14:25:37 CST 2016

Total time taken to generate the page: 0.28041 seconds