Home » Developer & Programmer » Reports & Discoverer » How to put department wise page break. (Reports 6i, Win XP)
How to put department wise page break. [message #354278] Fri, 17 October 2008 05:44 Go to next message
shajat
Messages: 25
Registered: October 2008
Location: INDIA
Junior Member
Hi,

How can I set department wise page break?

When the department change, I want page break.
Pl find the report attached.
Re: How to put department wise page break. [message #354469 is a reply to message #354278] Sun, 19 October 2008 09:22 Go to previous messageGo to next message
Littlefoot
Messages: 20901
Registered: June 2005
Location: Croatia, Europe
Senior Member
Account Moderator
I'd think about setting repeating frame's "Page Break" (before or after) property to YES.
Re: How to put department wise page break. [message #381883 is a reply to message #354469] Tue, 20 January 2009 03:54 Go to previous messageGo to next message
jolly_makkar
Messages: 63
Registered: March 2008
Member
Try this..
Select R_G_DEPT frame .go to property inspector....change property Maximum Records Per Page ...Change value from 0 to 1 .Run the report n see
Re: How to put department wise page break. [message #382167 is a reply to message #381883] Wed, 21 January 2009 04:01 Go to previous message
shajat
Messages: 25
Registered: October 2008
Location: INDIA
Junior Member
Yes, I got it.
Thankyou very much.
Previous Topic: Using conditinal operator in Formula column
Next Topic: Sub-queries in Discoverer - urgent!
Goto Forum:
  


Current Time: Fri Dec 09 01:49:43 CST 2016

Total time taken to generate the page: 0.14147 seconds